3 Car Stacker – Autolift HP2525 4 Post Storage Hoist

3 Car Stacker – 4500kg

The AL-HP2525 3 car stacker is designed to conveniently allow you to stack 3 vehicles when limited space is available. With a total lifting capacity of 4500kg (2500kg first platform/2000kgs second platform) and a generous headroom between platforms of 2100mm the stacker can store a wide range of vehicles.

Designed to withstand tough Australian conditions with a high-quality powder-coated finish and galvanised trays you can rest assured the range of HP car stackers is one of the best on the market!

Simple key switch operation makes it a breeze to operate and is ideal for various parking applications such as workshops, office buildings, valet parking, car rental locations, vehicle service centers or anywhere extra parking is required.

• Features a low 150mm drive on-ramp for easy loading of vehicles.
• Easy to operate key-operated control box, fitted with an emergency stop button.
• Low Voltage 24v Controls.
• Available in single and three-phase power options.
• Powerful 3kw hydraulic pump.
• Optional Galvanised trays between each set of platform ramps.
• Ramp stop plates located on each platform.
• AAQ recommends 200mm 25-32MPA Concrete for the AL-HP2525 Car Stacker

AL-HP2525 3 Car Stacker Operation

The HP2525 uses a much simpler and more reliable system than some competitors on the market, the lower platform is the master platform and is used to push/lift the upper platform up onto its locks.

Once the upper platform reaches the top of the column the four locks engage securing the platform in place. The lower platform is lowered down to the ground for the second car to be loaded. The lower platform can then be raised to the desired height.

A full locking ladder is incorporated into each column for the lower platform locks to engage in when rested. A safety limit switch will cut the operation of the platform at 2100mm from the ground. To take the vehicle higher simply turn the key switch back to center and back to raise – be careful when exceeding the safety limit switch height so accidental crashing of the vehicle to the upper platform does not occur.

HP Series Operation Procedure

Upper Platform Locks

Operation for the upper platform

Upper Platform Locks

Four locks on each column securely lock the top platform into place. The electronic actuated locks have a built-in pressure switch as an added safety measure should the lock not engage correctly.

Safety Limit

The HP2525 features a safety limit switch fitted to the column, this prevents the user from crashing the lower platform when loaded with a vehicle into the upper platform.

Lower Platform Locks

The lower platform is fitted with four locks on each corner which automatically engage with the locking ladder within each column when the desired lifting height has been reached.

Galvanised Drip Trays

The HP2525 is supplied with galvanised drip trays to prevent vehicle leaks to drip onto the below-stored cars. These are optional and do not have to be fitted for the operation of the car stacker.

3 KW Hydraulic Unit

Equipped with a powerful 3kw hydraulic power unit the HP2525 will lift up to 4000kg. Avaible in 240v 1Phase 15amp, or 415v 3phase

Single Hydraulic Ram

Low maintenance heavy-duty hydraulic ram drives the lower platform (master) and lift the upper platform (slave).

3 Car Stacker Dimensions

The HP2525 requires a 6.1m roof height to accommodate the hoist and standard-sized sedan on the top platform. Be sure you have adequate space before purchasing.

More info here